Scissors and a bowden tube can never end well


#1

What happens when you shorten the bowden tube a bit too much on the printer when fitting new quickconnectors? The head falls off when starting a print… and it can end up as a spectacular mess of magnetic joints going every which direction (untill they all fall off as well) if you have the tilt detection turned off due to false-triggering.

Just don’t ask me how I would know this! :laughing:


#2

I won’t ask. :wink:
But clearly a sense of humour is also required, which you thankfully seem to have in abundance. :smiley:


#3

Well, there’s no point crying over short tubes! :stuck_out_tongue: I really should have videod it… it was quite spectacular watching it slowly and thoroughly dismantle itself… rod by rod! :laughing: