Flux Set-Up Guide

Dear All,

Is there a set-up guide with screenshots anywhere?
I did a search for ‘guide’ but came up with nothing.
So far I’ve been following the steps I read on this forum here and there but worry I might have missed something out.
My IT savvy level is pretty low and i feel so drained just trying to get it to connect that i haven’t touched my flux for the last ten days…

On the third day with my flux I managed to get the flux connected to my computer once, and tried to 3d scan something. then it never connected again. This weekend i will move my computer and my flux right beside my router and work on it, just hope to get the right steps…

Thanks for reading, love from singapore :slight_smile:

1 Like

Check out the helpful instructions here: Comprehensive Flux Delta Setup and Guide

Perhaps that will help.

Here’re the “official” docs from Flux, too. https://flux3dp.zendesk.com/hc/en-us/sections/203692187-Initial-Setup

Just found a TYPO in the manual.

On their website, they state that the 3D printing area is 6.7" x 7" but the manual states differently. It states that it prints 6.6" x 8.2".

Even the dimensions are off…21.7" x 10.4" x 11.8" on the Web but the manual states 22.6" x 12.2" x 10.9".

I haven’t completely checked the manual but that stood out to me.