Camera Not seeing top of work

Hi Folks, My Beamo is performing well then yesterday the camera does not see the complete workspace. It doesn’t see the top 9/16" (4.3mm) so unable to engrave or cut in that area as it is blind to me. Here’s a picture of a box that appears to be at top of the software, but is 9/16" below a shifted to the right side. Any adjustment suggestions? Camera calibration doesn’t change the problem.
Thanks,
Gordon

Hi Gordon,

The top strip of the preview area is always hidden. Because the the laser head occupies that area, it’s in the way of the camera. For this reason, that area is cropped off during preview. However, you can still engrave and cut in that area without issue. It’s just hidden from view.

-Stewart