Unable to use the magnetic build plate


#1

I put the magnetic build plate on but whenever i run auto leveling or try to print file with z offset. The print head still jams into it no matter if i put 10, +10, or wtv value. Anyone else having this issue? I am afraid to try more as it is leaving dents on the build plate…


#2

What version of Flux Studio are you running, and have you updated the machine and toolhead firmware yet?


#3

i had the problem… get a new print mat from the flux store if you have holes in it. this is probably because its unable to calibrate the height due to the small difference of the holes, (probably a difference of 0.15mm) between the two patches.
if your mat has holes then post it here please. hope this helps!