Suggestions for partial bad print


#1

Looking for suggestions of things to try to make this a perfect print. Most of the body is great but the face looks bad. Everything is up to date and the .stl obviously does not look like this. I tried in medium and as seen in photo high quality.

Any suggestions would be appreciated.


#2

Looks like the machine is trying to lay down more plastic than will ‘fit’ and it’s causing the plastic to bulge out around the sides of the nozzle as it prints. That’s where the frills and ridges come from. I’d measure the filament diameter to see if it’s oversized and then either adjust that or the flow rate in the slicer to bring it back down to normal.