Out of filament Error with still filament on spool


#1

Hi,

Recently I keep getting Out of Filament Error message even when the spool is still have filament.
What is wrong with the printer? This Delta+ is less than 2 months old. Only PLA is used to print.


#2

Check to see if the filament detector switch is broken. You can find it when you insert the filament at the top of the printer. My detector wore out after around 1000hrs of printing but unless you have been printing no stop the detector could be faulty. You can turn off the filament detector switch off in the printers settings under preferences.


#3

I am not even near 10% of 1000hrs of prints. I’ve turn the filament detection off via the preference setting.