I really don’t like to print large or complicated items because of if someting goes wrong, and as i feared it happened again today. I am printing a large Ornstein statue and 13 hours in, this gap happened:
Okay no biggie i thought. I friction welded it together using some pla and my dremel so it wasn’t wobbly while the printer was still going so the print could be completed and i could just make it look better afterwards. but no i wasn’t that lucky. 89% through and the printhead ended up pushing the legs inside and i had to pause it. i fixed the leg but of course when i pressed start, the printhead continued about 1 cm above where it left and i had to abort the print. this was a 20 hour print and not the first time if something went wrong that the printhead continues way above where it left of. Am i the only one experiencing this and how can i make sure that if i pause it, it continues in the right height and palce?