Help Request


About the Help Request category (2)
Print not sticking (2)
Need new print head / parts (5)
Nozzle Clod? Molten filament spilling out near nozzle (3)
Top and Bottom layers not printing (16)
Filament overflow near nozzle, no problem printing but ugly lumps dripping (8)
I dread long prints (printhead will continue far above where it left of) (10)
How do i make a wider raft? this is going to be a HUGE fail (4)
Flux 3d printer power supply voltage and amperage rating (3)
How do I clean the oil marks on the flux's plastic? (2)
I want to develop tooheads! (4)
Endless Wifi Connection Problems on Mac (17)
Printing abruptly stalls (2)
Small dots on printed model (17)
Laser engraving process (4)
Random behaviour (2)
Flux Software 0.9.2 through 0.9.7 reports part out of print area for Simplify3D gcode (11)
Rear Motor makes a noise (5)
Cutting display is blank (2)
Change filament issue (3)
3d Modeling software glitch (1)
Filament not loading (was working) (12)
Printer not responding (14)
Issues after not using FLUX for awhile (6)
Old Flux - New issue (8)
Laser calibration chart (10)
FLUX not responding (2)
Tell me how your fans behave. Are mine normal? (2)
Blockage inside the printing toolhead heater block (5)
Can no longer connect to flux? (3)